A Dedicated Pancake Force Sensing Division
A Heavy-Duty & Metrology Force Sensing Division of Magatom Dynamics Co., Ltd.
Mechanical fit and measurement planning for OEM teams.
PancakeLoadCells.com is the focused MT-PLC product channel of Magatom Dynamics Co., Ltd. for low-profile pancake and spoke-type force transducer enquiries.
Our engineering intake brings together required force, flange dimensions, loading hardware, bridge outputs and the installed calibration boundary. It supports materials laboratories, servo-press builders, structural test integrators and process-equipment teams.
Request configuration-specific drawings, inspection requirements, calibration scope and commercial terms. Product certification, traceability, sealing and fatigue evidence are supplied for the agreed configuration rather than inferred from the family name.
inquiry@pancakeloadcells.comPublished and reviewed 2026-10-27 · Responsible publisher: Magatom Dynamics Co., Ltd.
Ask for the record behind each manufacturing decision.
Confirm the inspection and calibration scope for the quoted build. The following record chain defines what to review before accepting the assembly.
| Stage | Evidence to request | Decision supported |
|---|---|---|
| Material condition | Material designation, heat/lot identity and requested inspection certificate. | Confirm 17-4PH or alloy-steel condition and the intended environment. |
| Machined load path | Released revision, flange/pilot dimensions, thread gauges and dimensional inspection. | Confirm that the complete installed interface matches the approved drawing. |
| Bridge and cable assembly | Bridge resistance, insulation, sensitivity, polarity, pin assignment and strain relief. | Check each independent bridge and the receiving amplifier. |
| Sealing and load envelope | Assembly-specific environmental test and required static / fatigue load evidence. | Review exposure and force spectrum; do not infer a rating from appearance. |
| Final calibration | Sensor/assembly serials, setup, force points, uncertainty and reference-standard records. | Approve the defined measurement chain and acceptance method. |
Bring the load path.
We’ll review the fit.
Send your capacity, center thread and mounting envelope. Include the full original part number when replacing an installed sensor.
CAD and test reports are supplied for the agreed configuration. No generic drawing is presented as an approved production part.